Annex IV Principles for monitoring and reporting referred to in Article 14(1)
Part A - Monitoring and reporting of emissions from stationary installations
Monitoring of carbon dioxide emissions
Emissions shall be monitored either by calculation or on the basis of measurement.
Calculation
Calculations of emissions shall be performed using the formula:
Activity data × Emission factor × Oxidation factor
Activity data (fuel used, production rate etc.) shall be monitored on the basis of supply data or measurement.
Accepted emission factors shall be used. Activity-specific emission factors are acceptable for all fuels. Default factors are acceptable for all fuels except non-commercial ones (waste fuels such as tyres and industrial process gases). Seam-specific defaults for coal, and EU-specific or producer country-specific defaults for natural gas shall be further elaborated. IPCC default values are acceptable for refinery products. The emission factor for biomass that complies with the sustainability criteria and greenhouse gas emission-saving criteria for the use of biomass established by Directive (EU) 2018/2001, with any necessary adjustments for application under this Directive, as set out in the implementing acts referred to in Article 14 of this Directive, shall be zero.
If the emission factor does not take account of the fact that some of the carbon is not oxidised, then an additional oxidation factor shall be used. If activity-specific emission factors have been calculated and already take oxidation into account, then an oxidation factor need not be applied.